Battery

1. Carefully wedge open the tab on the bottom of the Photon case using a nail file or small screwdriver.

2. Replace with either one CR-2032 or two CR-2016 Lithium Batteries (depending on beam color) with the plus (+) side up (see figures immediately above).
3. Close by aligning tab and snapping shut.
   
   Note: In the event of water penetrating the case, simply open the case and allow to dry.

Note: Press firmly with screwdriver to

avoid damage to screw or driver tip.

1. Remove four screws from the bottom of the light & flip case back over so the switch is on top.

2. Carefully separate top & bottom case.

3. Remove clear slide-switch.

4. Hold down bulb with one finger & lift lead wire just enough to remove battery(s)*.

5. Install new battery(s).

6. Replace slide-switch on slightly raised lead.

7. Position top case so slide-switch
   extends through hole & close case. 

8. Flip over & replace screws.

*Important: Change position of bulb leads 

only enough to replace batteries. 

1. Carefully wedge open the tab on the logo side of the Photon Micro-Light with a ball point pen or the point of a nail file.

2. Replace with either, one CR-2032 or two CR-2016 lithium batteries (depending on beam color). Install with the + side toward the cap (see drawing). Make sure the battery(s) is under the metal strap.

3. Close case by aligning tab in slot and snapping shut.
   
   Note: In the event of water penetrating the case, simply open the case and allow to dry.

See Technical Specs for additional battery information.

       click for details

         Shipping

Better Mousetraps

dba: The Original...

microlightstore.com
Fairfield, Ohio